Specification
Inground uplight, IP67, Class I
– Front cover in 316 stainless steel brush finished.
– Corrosion resistant Deep-Drawn stainless steel housing.
– Small vehicles can drive over the luminaire at low speed (maximum 20kgm/hour). Withstand maximum load 2,000 kgs.
– Recessed housing made of GFR polymer.
– Impact resistant safety tempered glass cover. Able to withstand the temperature up to 250°C.
– Glass flushes to the front cover, no accumulation of dust and water.
– High performance anodized spun aluminium reflector.
– Post-cured treated silicone gasket. Temperature and weather resistant. Working temperature -40°C to +200°C.
– External screws are in stainless steel with protection dipping.
– Cable entry protected by M20 cable gland. To be used with H05RN-F/ H07RN-F cable with 7-13mm. diameter.
– G12 lampholder in ceramic body from BJB or equivalents. VDE/ ENEC approved.
– Vacuum impregnated magnetic ballast for HID lamp from Vossloh Schwabe/ BAG Electronics or equivalents. ENEC approved.
– Aluminium case capacitor with over pressure safety device from Italfarad or equivalents. ENEC approved.
– Electronic ignitor with automatic switch-off function from Vossloh Schwabe or equivalents. ENEC approved.
– The whole systems tested to be operated under maximum ambient environment up to +40°C.
– Tinned copper conductor with silicone insulated internal wire from ENCO or equivalents. IMQ approved. Working temperature -40°C to +180°C.
– Terminal Block/ Connector Class1 luminaire provided with the earth connection.
– Pre-wired with 3×1.0mm. H07RN-F neoprene cable from Aristoncavi or equivalents. IMQ approved.
– Equipped with anti-humidity kit.
– Caution Installation work has to be carried on according to the enclosed installation manual.
– The water drainage system must be tested to ensure that it is sufficiency and efficiency.
