Specification
Bollard, IP65, Class I
– IEC 60598-1 General Requirement
– IEC 60598-2-1 Fixed Luminaires
– Protection against mechanical impact IK10 on body and optical part.
– High-pressure Die Cast Aluminium alloy body and components.
– Extruded Aluminium S6063 alloy body with low copper content.
– Nano Ceramic surface conversion, resistant to corrosive environment.
– Primarily coated with epoxy resin and top coated with UV stabilized polyester powder.
– Cured in digital temperature controlled chamber at 200°C.
– Self-extinguishing high impact resistant clear polycarbonate diffuser.
– Diffuser with UV stabilized additive material from Teijin – Japan.
– Glare shield slanted aluminium louvers.
– Weather resistant silicone gasket. Working temperature -40°C to +200°C.
– External screws are in stainless steel with protection dipping.
– Cable entry protected by weather proof EPDM grommet.
– To be used with H05RN-F/ H07RN-F cable with 7-10mm. diameter.
– G24q/ GX24q lampholder in PBT body from AAG Stucchi or equivalents.
– Electronic ballast for fluorescent lamp from TCI/ Tridonic or equivalents.
– Tinned copper conductor with silicone insulated internal wire from ENCO or equivalents.
– Internal wire with IMQ approved. Working temperature -40°C to +180°C.
– Terminal block in GFR PA6.6 for cable with cross section up to 2.5mm². VDE approved.
– Class1 luminaire provided with the earth connection.
– Installation work has to be carried on according to the enclosed installation manual.
